Description
The GE Fanuc IC695PSD040G is a high-efficiency 40-watt isolated power supply module designed specifically for the PACSystems RX3i programmable automation controller (PAC) series, delivering stable 24 VDC backplane and auxiliary power for industrial control systems.
📋 Technical Specifications Datasheet
- Brand: GE Fanuc (Emerson / GE Intelligent Platforms)
- Model: IC695PSD040G
- Series: PACSystems RX3i
- Product Name: 40W 24 VDC Power Supply Module
- Manufacturing Origin: United States
- Product Status: Industrial Standard / Active Product Line
- Dimensions: Standard RX3i single-slot module form factor
- Weight: Approximately 0.45 kg
- Original Equipment Manufacturer: GE Fanuc Automation
- Power Rating: 40 Watts total output power (supports 24 VDC input / isolated output rails)
⚙️ Operating Norms and Usage
- Handle the power supply module using proper anti-static wrist protection and store in ESD-safe packaging.
- Insert the module securely into the designated power supply slot on the left end of the RX3i backplane, ensuring backplane connector pins are fully engaged.
- Wire the incoming 24 VDC power source to the front removable terminal block with correct polarity, ensuring proper earth grounding to the backplane chassis stud.
⚡ Power-On / Power-Off Sequence
- Power-On Sequence: Verify incoming 24 VDC supply voltage and polarity, energize the input power feed, and observe the front panel LED indicators (such as OK, OLOAD, and BOK) to confirm normal startup.
- Power-Off Sequence: Save active PLC programs and configurations if necessary, de-energize the incoming 24 VDC power source, and allow internal circuits to discharge before module extraction.
📖 Product Usage Instructions
- Monitor the front-panel status LEDs to continuously verify power supply health, backplane status, and overload warnings.
- Avoid exceeding the 40W total power budget across the RX3i backplane and auxiliary outputs when adding expansion modules.
- Periodically check terminal block screw torques and cabinet ventilation to ensure reliable electrical contact and prevent thermal stress.
❓ Common Questions & Answers Q&A
- Q: What does the OLOAD (Overload) LED indicate when lit?
A: It indicates that the power demand from the modules installed on the backplane exceeds the 40W capacity of the supply; reduce the module load or upgrade to a higher-capacity power supply.
- Q: Can this power supply accept AC input voltage?
A: No, the IC695PSD040G is specifically engineered for a 24 VDC input feed; for AC input requirements, use an alternative model such as the IC695PSA040.
Recommended Alternative Series & Models
- GE Fanuc Power Supply: IC695PSA040 (AC Input 40W Power Supply)
- GE Fanuc Power Supply: IC695PSD100 (100W 24 VDC Power Supply)
- GE Fanuc CPU: IC695CPU310-FS
- GE Fanuc CPU: IC695CPU315
- GE Fanuc Backplane: IC695CHS012
- GE Fanuc Backplane: IC695CHS007
- GE Fanuc HMI: IC754VCI06STD-BB
- GE Multilin Relay: SR750-P1-G1-S1-HI-A20-R-E-H
- GE Mark VIe Module: IS420UCSCH1A
- GE Drive Board: 531X301DCCAFG2
